Euchner EKS FSA with Profibus-DP Interface Manuel d'utilisateur télécharger pdf (Page 34)

Manual EKS Electronic-Key Adapter Profibus-DP

Job in progress

The job is now executed. The execution of the job is signaled automatically in the input area of the bus master

in byte no. 0 (status byte) (see section

8.6.1) by the value 1 in bit no. 7. Once job execution has been started, bit

no. 6 (read) or bit no. 7 (write) in byte no. 0 (command byte) in the output area of the bus master must be again

reset to the value 0.

Job finished

The successful completion of the job is signaled automatically in the input area of the bus master in byte no. 0

(status byte) (see section

8.6.1) by the value 1 in bit no. 6 (job finished).

13.2 Input area of the bus master

Figure 10: Input area of the bus master, example based on SIMATIC S7

092009-03-10/07 Subject to technical modifications Page 34/36

1 2 ... 29 30 31 32 33 34 35 36

Pas de commentaire

Euchner EKS FSA with Profibus-DP Interface Manuel d'utilisateur Page 34