Euchner MGB (V1.2.3) Manuel d'utilisateur

MGB Help for Setup and Service (up to V1.2.3)

MGB Help for Setup and Service 3 System status tables 3.1 MGB-AR Operating mode LED indicator State Input fault Ready for teach-in Output fault

MGB Help for Setup and Service 3.2 MGB-AP Operating mode LED indicator State Input fault Ready for teach-in Output fault Diagnostics Signal sequ

EUCHNER GmbH + Co. KG Telephone +49 711 7597 – 500 (Support) Kohlhammerstraße 16 Fax +49 711 753316 D-70771 Leinfelden-Echterdingen www.euchne

MGB Help for Setup and Service Page 2/12 Subject to technical modifications 115387-01-04/12

MGB Help for Setup and Service Table of contents 1 Connection...

MGB Help for Setup and Service 1 Connection 1.1 Connection of the buttons in the MGB The terminal assignment of the switches (lights, buttons, emerge

MGB Help for Setup and Service 1.3 Parallel control of the guard locking The guard locking solenoids are supplied from voltage UA. The inputs UCM serv

MGB Help for Setup and Service 2 Troubleshooting 2.1 LED DIA 1 flashes 2 times (separate operation) Fault symptom: The MGB displays the fault state

MGB Help for Setup and Service 4. Switch the voltage on again or release the reset button 5. Wait until LEDs DIA1 flash three times or stop flashing

MGB Help for Setup and Service 2.5 LED DIA 1 flashes 6 times (AR version) Fault symptom: The MGB displays the fault state “signal sequence incorrect”

MGB Help for Setup and Service 2.7 Separate operation functions on the safety relay, but not series operation Fault symptom: The connection of a separ