Euchner AS-i 3.0 Command Interface Manuel d'utilisateur télécharger pdf (Page 67)

AS-i 3.0 Command Interface Commands of the Command Interface

Subject to reasonable modifications due to technical advances Id.-No.: 102875 Issue date - 3.12.2007 EUCHNER GmbH + Co. KG

Kohlhammerstraße 16, D-70771 Leinfelden-Echterdingen Tel. +49/711/7597-0, Fax +49/711/753316

4.7.4 Enhanced diagnosis

Since the "Safety at Work“ monitor diagnosis is longer than the maximum size of

the command interface, it must be read with several adjacent requests.

The byte 5 (‘index’) declares the start index in the array of diagnostic data. If this

start index is 0, the whole diagnosis is fetched from the monitor and stored to an

internal buffer. Otherwise, the AS-i Master will respond out of the internal buffer.

Thus, even though several requests are necessary to read the whole buffer, data

integrity is maintained.

The diagnosis array is set up as follows:

Request

byte

17E

1. L=1 long diagnosis for advanced monitor

2. U=1 unsorted diagnosis (all devices)

circuit

302

4 slave address

5 index

Response

byte

17E

2T result

3 diagnosis byte #index+0

4 diagnosis byte #index+1

……

n diagnosis byte #index+n-3

Safety Monitor Diagnosis Array

"basic function range" and "sorted by OSSD"

byte

000

1 state of monitor

2 state of OSSD 1

3 state of OSSD 2

4 number of devices not green, OSSD1

5 number of devices not green, OSSD2

6 device index 32, OSSD 1

7 color of device 32, OSSD 1

8 device index 33, OSSD 1

9 color of device 33, OSSD 1

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 97 98

Pas de commentaire

Euchner AS-i 3.0 Command Interface Manuel d'utilisateur Page 67